next up previous contents index
Next: The rhost Command Up: Simulation Control Commands Previous: The reset Command   Contents   Index


The resume Command

The resume command will resume an analysis in progress. The simulation can be stopped by typing an interrupt (Ctrl-C) or with the stop command. If no analysis is currently in progress, the effect is the same as the run command. Each circuit can have one each of a standard analysis, a loop analysis (started with the loop command), and a margin analysis (from the check command) in progress. The resume command will resume standard analysis, margin analysis, and loop analysis in that precedence. Paused margin and loop analysis can also be restarted with the check and loop commands. These commands, and the reset command, can be used to clear stopped analyses. The resume command takes no arguments.



Stephen R. Whiteley 2022-09-18